87 documents
The Document Library
Search everything published — by keyword, or by narrowing the filters.
SectionWater MarketplaceSectionLabs & QualitySectionProcesses & OperationsSectionReuse & ResilienceClear all
- Article· Water MarketplaceHow to Write a Water Treatment Equipment Specification: A Buyer's GuideA well-written equipment specification is the single most important document in a water treatment procurement. This guide covers the minimum technical content for membrane systems, pumps, analysers and chemical dosing equipment, along with the contractual and performance-testing provisions that protect the buyer.3 Nov 2026Read article
- Article· Reuse & ResiliencePotable Water Reuse: Treatment Trains, Risk Frameworks and Regulatory ApproachesDirect and indirect potable reuse (DPR/IPR) are gaining regulatory acceptance globally as a drought-resilient supply source. This article reviews the treatment trains used by leading utilities, the multi-barrier risk frameworks employed, and the lessons from operational deployments in Singapore, California, and Singapore.3 Nov 2026Read article
- Article· Labs & QualityISO/IEC 17025 Accreditation for Water Quality Laboratories: A Practical GuideISO/IEC 17025:2017 is the international standard for testing and calibration laboratory competence. This guide outlines the key requirements, common non-conformities in water quality laboratories, and practical steps for achieving and maintaining accreditation under a national accreditation body.3 Nov 2026Read article
- Article· Processes & OperationsCT Disinfection Control: Managing Chlorine Contact Time in Drinking Water PlantsCT (concentration × time) is the regulatory metric for drinking water disinfection efficacy. This article explains how to calculate, monitor and optimise CT under variable flow, temperature and pH conditions, with worked examples for free-chlorine, chloramine and UV systems.3 Nov 2026Read article
- Technical guide· Water MarketplaceController Quick StartFirst power-up, network configuration and the default alarm thresholds.3 Nov 2026Open the guide
- Technical guide· Water MarketplaceMaintenance and Overhaul GuideScheduled maintenance intervals, wear limits, seal replacement and bearing service procedures.3 Nov 2026Open the guide
- Technical guide· Water MarketplaceInstallation and Commissioning ManualMechanical installation, alignment tolerances, electrical termination and the commissioning checklist.3 Nov 2026Open the guide
- Support· Water MarketplaceSX-200 will not startDiagnosing a pump that draws no current on demand.3 Nov 2026Get help
- Tip sheet· Processes & OperationsWet Well Maintenance ChecklistTen checks that prevent most emergency callouts.3 Nov 2026Read the tips
- Report· Reuse & ResilienceSubscribersSustainability Report 2025Verified performance against our published commitments.3 Nov 2026Open the report
- Video· Water MarketplaceSX-200 Installation WalkthroughRail system fitting, cable routing and first-start checks.3 Nov 2026Watch
- FAQ· Water MarketplaceHow often should submersible pumps be serviced?Service intervals depend on duty and medium, not calendar time alone.3 Nov 2026See the answer
- Case study· Processes & OperationsRiyadh Lift Station ModernisationReplacing 14 ageing lift-station pumps cut blockage callouts by 71% and energy use by 19%.3 Nov 2026See the case
- Article· Processes & OperationsReducing Non-Revenue Water with District MeteringDistrict metered areas turn an unmanageable network-wide loss figure into a set of tractable local problems.3 Nov 2026Read article
- Article· Processes & OperationsCutting Aeration Energy in Activated-Sludge PlantsAeration typically consumes 50–60% of a treatment plant’s electricity. Most of that is recoverable without new blowers.3 Nov 2026Read article
- Blog post· Processes & OperationsWhy the pump curve on the datasheet is not the one you getEvery curve is measured on clean water at a fixed speed. Here is what suction conditions, wear rings and a worn impeller do to it.28 Oct 2026Read the post
- Article· Reuse & ResiliencePotable: an introductionWhat Potable covers within Water Reuse, the questions it answers in practice, and where to read next.26 Oct 2026Read article
- Blog post· Processes & OperationsCommissioning a pump station in a weekWhat was specified, what we found on site, and the four changes that made the difference.23 Oct 2026Read the post
- Article· Reuse & ResilienceMulti-Barrier: an introductionWhat Multi-Barrier covers within Reuse Standards, the questions it answers in practice, and where to read next.23 Oct 2026Read article
- Technical guide· Water MarketplaceInstruments & Analysers: an introductionWhat Instruments & Analysers covers within Product Categories, the questions it answers in practice, and where to read next.22 Oct 2026Open the guide
- Article· Processes & OperationsPressure: an introductionWhat Pressure covers within Distribution Systems, the questions it answers in practice, and where to read next.21 Oct 2026Read article
- Article· Reuse & ResilienceResource/Nutrient/Energy Recovery: an introductionWhat Resource/Nutrient/Energy Recovery covers within Circular Water, the questions it answers in practice, and where to read next.20 Oct 2026Read article
- Article· Processes & OperationsJar Testing: an introductionWhat Jar Testing covers within Coagulation & Clarification, the questions it answers in practice, and where to read next.18 Oct 2026Read article
- Article· Labs & QualityProficiency: an introductionWhat Proficiency covers within Calibration & QA/QC, the questions it answers in practice, and where to read next.12 Oct 2026Read article